About Store Forum Documentation Contact



Post Reply 
Use of Chinese font - causes error ?
Author Message
RedcrowProd Offline
Member

Post: #1
Use of Chinese font - causes error ?
Hi,

I have a font of roughly 20mb that I'd like to use for chinese / jap / korean languages.

It works fine in the editor, but when i try to build, it has error 1023
and another one where it creates 80m images ?

i have reduced it slowly, and it seems that 1 font using this type is fine, but anymore than 1 and it causes the issue seen in the screenshot.

i can share the font if needed


Attached File(s) Image(s)
       
11-13-2023 10:03 AM
Find all posts by this user Quote this message in a reply
Esenthel Online
Administrator

Post: #2
RE: Use of Chinese font - causes error ?
Reduce your font "Size", with these settings your font size can reach 2GB+.
11-13-2023 10:17 AM
Find all posts by this user Quote this message in a reply
RedcrowProd Offline
Member

Post: #3
RE: Use of Chinese font - causes error ?
oh i see how this works now, thanks that did the trick !

do you typically have asian and other font separated ?
200mb per font still seems a bit excessive, but else the resolution is too low on latin alphabet
11-13-2023 07:55 PM
Find all posts by this user Quote this message in a reply
Esenthel Online
Administrator

Post: #4
RE: Use of Chinese font - causes error ?
Yes I separate. The font with asian will have lower size, and font without, will have bigger size.
11-14-2023 04:46 AM
Find all posts by this user Quote this message in a reply
RedcrowProd Offline
Member

Post: #5
RE: Use of Chinese font - causes error ?
ok i see, unfortunately i dont think this could be working for my project, since i can have a mix of chinese and latin alphabet together.

would be it complex to change size to have 2 separate entries, one for ASCII character, one for the other character, not sure how that would work ?
(This post was last modified: 11-14-2023 05:47 AM by RedcrowProd.)
11-14-2023 05:46 AM
Find all posts by this user Quote this message in a reply
Post Reply