About Store Forum Documentation Contact



Post Reply 
Mesh Editor - Problem with Orthogonal view
Author Message
Tottel Offline
Member

Post: #1
Mesh Editor - Problem with Orthogonal view
When I put the view mode to orthogonal and then Reset the camera, I get these black regions where my specular should be. If I now move the camera, it remains black until I put it Orthogonal back off.
If I now put it back to orthogonal, there is no problem until I reset the camera.

http://img337.imageshack.us/img337/1729/cubel.png
12-27-2010 12:57 PM
Find all posts by this user Quote this message in a reply
Esenthel Offline
Administrator

Post: #2
RE: Mesh Editor - Problem with Orthogonal view
Hi,

Thanks, that's just the Near Clip Plane of camera/viewport.

I'll try to remove it for next release.
12-29-2010 04:00 PM
Find all posts by this user Quote this message in a reply
Post Reply